Truck Bed Upgrade on Oconee Ranger District, Georgia
Subject: Truck Bed Upgrade on Oconee Ranger District, GeorgiaSolicitation Number: 12444026Q0126Notice Type: SOLICITNAICS: 811121Set-Aside: Total Small BusinessNotice Published: 07-09-26Response Due: 07-19-26Agency: Department of AgricultureOffice: FOREST SERVICEContact: Katie Morgan This email address is being protected from spambots. You need JavaScript enabled to view it. Ph: (706) 485-7110Office Address: Atlanta, GA 303092449Place of Performance: GA 31024Related Notices:
Click for official SAM (FBO) notice, additional information, and accompanying attachments
*see attachments Statement of Work (SOW) 2026 Chevrolet 3500 HD (Single Rear Wheel) OEM Bed Removal and Installation of CM Truck Bed ? Model 8'6/84/54/42 1. Vehicle Information ? Make/Model: 2026 Chevrolet 3500 HD ? Configuration: Single Rear Wheel ? Current Condition: Equipped with factory?installed OEM pickup bed and back up camera on factory installed bed ? VIN: 1GC4KSEY1TF291258 2. Contractor Responsibilities The contractor shall perform the following: A. Removal of Factory Bed ? Safely disconnect all electrical, back up camera, sensors, fuel filler, and auxiliary connections tied to the OEM pickup bed. ? Remove factory bed without damage to the truck frame, chassis wiring, or components. ? Inspect and clean mounting points on the frame after bed removal. B. Preparation for Upfit ? Verify chassis measurements and mounting compatibility for CM model 8'6/84/54/42. ? Ensure all wiring harnesses, lighting connectors, and fuel filler components are positioned for proper integration with the new bed. ? Provide any necessary mounting hardware if not included by the manufacturer. C. Installation of CM Truck Bed (Model 8'6/84/54/42) ? Properly mount and secure the CM bed to manufacturer specifications and torque requirements. ? Align and install fuel filler neck, rear lighting, license plate lighting, and reverse sensors (if applicable). ? Connect and test all electrical systems including brake lights, turn signals, reverse lights, and marker lights. ? Ensure the bed sits level, securely fastened, and free of vibration or interference with vehicle components. D. Quality Check and Testing ? Perform full inspection confirming structural security, proper alignment, and correct electrical function. ? Test vehicle lighting and safety systems to ensure compliance with DOT requirements. ? Verify proper clearance between bed, tires, frame, and suspension components. 3. Deliverables ? Completed removal of OEM bed ? Fully installed CM Truck Bed (Model 8'6/84/54/42) ? Documentation of all work performed 4. Schedule ? Work to begin on: 8/1/26 ? Estimated completion: 8-12 weeks 5. Acceptance Criteria The installation will be considered complete when: ? CM bed is mounted to manufacturer specifications ? All electrical and safety systems function correctly ? No fault codes or warning indicators are present ? Vehicle passes final inspection by the government/agency representative 6. Additional Requirements ? Contractor must follow all safety protocols and industry standards. ? Any changes, unexpected issues, or additional parts required must be approved before proceeding.